Installation instructions
Before you begin installing large stickers, make sure to clean the surface where you'll be applying them. Use isopropyl alcohol to remove any dirt or residue that might prevent the stickers from adhering properly. Dry the surface thoroughly before you start.
Applying the stickers
For large stickers, it is recommended to start by aligning the top of the sticker with the surface. Use a plastic squeegee to smooth the sticker gradually, removing any air bubbles as you go. Continue this process until the sticker is completely adhered to the surface.
Finishing and maintenance
Once the large sticker is perfectly applied, use a soft cloth to smooth out any imperfections and ensure good adhesion. To care for the sticker, avoid harsh chemicals and do not use abrasive cleaners. Large stickers can add a unique touch to your space, so take good care of them to enjoy them for a long time.
Required materials
Clean & dry cloth
Painters tape
Scissor
Ideal surfaces
Smooth, dry and clean surfaces, treated with primer and a minimum of one coat of paint
Please wait a minimum of 15 days before installing on a freshly painted surface
Surfaces to avoid
Dirty, moldy or dusty surfaces
Textured, damaged or peeling surfaces
*it is not recommended to install your mural directly on brick, wood, gypsum, primer or plaster
Watch our installation video
View video
1. Preparing the surface
The surface must be smooth, clean and dry. You can use a damp cloth to ensure no dust remains on the wall. Ensure that no residue is on the wall, such as drips of dry paint and be sure to well sand any imperfections as they may show through the vinyl.It is important to wait at least 2 weeks after the wall has been painted before installing your mural.
2. Preparing your installation
It is recommended to have two people for the installation.
Visualize where you want to install your decal by placing it on the wall with some masking tape.
3. Peel the top
When satisfied with the decal’s location, peel off 2 inches at the top of the decal and cut the backing paper. Apply this section to the wall by pressing it lightly with your fingers. When the top of the decal has been applied to the wall, you can remove the masking tape.
4. Take off the backing
Peel slowly the rest of the backing paper while pressing the decal on the wall so that it may stick to the wall.
5. Bubbles
Once all the panels are installed, you can cut away any excess vinyl with your exacto style knife.
View or download our PDF
View PDFAny questions ?
We are easy to reach and it would be our pleasure to answer any questions or ease any concerns.
